Raing 額定: DC 30V 50mA

規格詳情說明：

ELECTRICAL (電氣特性):

(接觸電阻) INITIAL CONTACT RESISTANCE: 50mΩ Max.

(操作力量) OPERATION FORCE: 400gf±100gf

(絕緣電阻) INSULATION RESISTANCE: 100MΩ Min. 250VDC

(電氣壽命) ENDURANCE: 10,000 CYCLES

(耐電壓) WITHSTAND VOLTAGE: AC 500V  rms(50-60Hz)FOR  1  MIN  TRIP CURRENT:0.5mA

(使用溫度范圍) PRACTICAL TEMPERATURE RANCE: -16℃～+60℃

(耐焊性試驗) RESISTANCE TO SOLDERING HEAT TEST:

    *SOLDERING IRON METHOD:BIT TEMPERATURE 350±10℃ APPLICATION TIME OF SOLDERING IRON3±0.5SEC 

     HOWEVER EXCESSIVE PRESSURE SHALL NOT BE APPLIED TO THE TERMINAL.

    *手焊接的時候溫度控制在 350±10℃,時間為 3±0.5 秒,但不能在排腳上施加異常壓力。

(耐冷試驗) COLD TEST:

     *THE SWITCH SHALL BE STORED AT A TEMPERATURE OF -25±3℃ FOR 96 HOURS.THEN THE SWITCH SHALL BE MAINTAINED

       AT STANDARD ATMOSPHERIC CONDITIONS FOR 1 HOUR AFTER WHICH MEASUREMENT SHALL BE MADE.

     *放置在溫度-25±3℃中 96 小時后,再將放置在常溫常濕的環境中 1 小時后進行測試.

(耐熱試驗) HEAT TEST:

     *THE SWITCH SHALL BE STORED AT ATEMPERATURE OF 70±2℃ FOR 96 HOURS.THEN THE SWITCH SHALL 

       BE MAINTAINED ATSTANDARD ATMOSPHERIC CONDITIONS FOR 1 HOUR AFTER WHICH MEASUREMENT SHALL BE MADE.

     *放置在溫度 70±2℃中測試 96 小時后,再將放置在常溫常濕的環境中 1 小時后進行測試.